Cos with the bare, reset, config it did do an ADSL sync ok, which surprised me.Īnyway, result. To access the router, open a web browser, go to the address bar and enter 192.168.1.1, which is the IP address common to most routers.
#Technicolor router default ip password
Makes me wonder if the config has a check that it will only let you config if you're hooked up to Plusnet. Default username and password for technicolor router tc8715d All four versions of the NETGEAR WNR1000 router ship with a default username, password, and IP address. I think it did go awol and in spite of many attempts to reconfigure, the re-try with the phone line connected seemed tpo remind it what to do. But we're back, faster than the spare router I was on. It did take quite a few attempts, though, especially at getting the WiFi config to "stick". Link your computer to the internet using Spectrum Wi-Fi to log into your Spectrum router. I reconfigured the account DSL login and my own WiFi SSID/pw and kaboom!, here we are. Spectrum Router Default IP, Username, and Password. The router allowed me in, and had connected to Plusnet using a default login (not my login) The "only" difference is, when trying to log in to the router to reconfigure it, I had the phone line re-connected (I had had this before but it had not made any difference, but it's true the bulk of my router-admin-login attempts were without the phone line connected) MX-230 M1 default Password, Login & Gateway settings : Default Gateway IP: 192.168.1. If you change the router IP address to 192.168.2.254 and leave the the subnet mask as 255.255.255.0 then the pool of IP address must match and be somewhere in the range 192.168.2.1 to 192.168.2.253. The BEC Technologies MX-230 M1 router has No WiFi, 1 Gigabit ETH-ports and 0 USB-ports.
#Technicolor router default ip serial
Username admin and password is serial number, as expected The router hands out a pool of IP addresses to the devices you connect to it by a process known as DHCP. Router has leapt into life Wanted to try once more before I used the hammer solution
0 kommentar(er)
